WDLXTV-Plus-0.4.3.1 discussion thread

[b-rad.cc]

Discuss here.

Download here

Minor point to note - linksheets moviesheets are enabled

Look for LINKSHEETS setting under webend configurator or execute:

Code: Select all

config_tool -c LINKSHEETS=ON

reboot required.

for those unhappy with 0.4.3.1 who wish to go back to a fully working version:
1.03.29_WDLXTV.COM_WDLXTV_PLUS-0.4.2.3

0.4.3.2
flash:
1.03.39_B_WDLXTV.COM_WDLXTV_PLUS-0.4.3.2
usb boot:
1.03.39_B_WDLXTV.COM_EXT3-BOOT_PLUS-0.4.3.2

[wookiebush]

I posted a new thread at the same time B-rad put this one up. Sorry for the dupe.

Here is my original post:

Just pulled down a new version from the update server.

Only issue so far is that Netflix wont even launch. Goes to a black screen. I've rebooted and reset factory defaults. Haven't seen any other posts about this version. Maybe I jumped the gun a little?

Keep up the great work! I look forward to each new release!

EDIT: Hope you are feeling better B-Rad!

EDIT EDIT: Yay Movie sheets!

[kismiace]

b-rad just thought i would let you know that the member links for ext-3 and regular firmware are not working.

[jackie999]

I'm not too sure what to do at this point..I turned on and saw there was a download so I accepted. It completed and shut itself off. It came back on but just the power light was on...now that is all there is...nothing else. I tried the paper clip reset but noting..just the power light, black screen. Any suggestions?

[b-rad.cc]

i've gotta rebuild my serial cable tonight and then i'll sort netflix. the background in webend doesnt work too when linksheets is enabled, so two minor issues to sort and should be good.

getting closer

@kismiace: links fixed

[gilgamesh_48]

I'm not too sure what to do at this point..I turned on and saw there was a download so I accepted. It completed and shut itself off. It came back on but just the power light was on...now that is all there is...nothing else. I tried the paper clip reset but noting..just the power light, black screen. Any suggestions?

I could not get any of the 1080 resolutions or auto to work via HDMI so I temporarily hooked up via composit and set my box to 720p and that is working fine.

If you are using HDMI try something else to see if you are having a problem like mine/

[Harry_Y]

I loaded up 0.4.3.1 earlier and found the Netflix was not working.

When I tried to roll Back to 0.4.2.3 my unit locked up and
upon power off and on again I got a corrupt firmware screen.

I loaded the original Factory firmware on a USB drive and it did load.

I then reloaded version 0.4.2.3 and am back up and running

Note: I did have a little trouble at one point getting the factory
firmware to load and had to switch to using the other USB port.

I do not recall for sure the port that did correctly work but I think It was port #1

[jackie999]

Thanks gilgamesh_48 - I switched to RCA cable and it's working..I'll have to downgrade thou..picture is horrible

[gilgamesh_48]

Thanks gilgamesh_48 - I switched to RCA cable and it's working..I'll have to downgrade thou..picture is horrible

Switch the WD's resolution to 720p and your HDMI may work, mine is at 720p.

[haibane]

Is there supposed to be a wdtvlive.ver vile in the ext3 version? I can't get it to upgrade to it