Ixar wrote:That's great, but how did you make it work ?
I am curious to know how you solve the kernel module symbol issue.
eth0 Link encap:Ethernet HWaddr 00:90:A9:72:18:A8
inet addr:10.0.77.15 Bcast:10.0.77.255 Mask:255.255.255.0
inet6 addr: 2001:470:xxxx:xxxx:2011:404a:bb15:4695/64 Scope:Global
inet6 addr: 2001:470:xxxx:xxxx:3958:ae83:f68a:d638/64 Scope:Global
inet6 addr: 2001:470:xxxx:xxxx:29df:ccfc:bf56:83a8/64 Scope:Global
inet6 addr: 2001:470:xxxx:xxxx:74e1:8898:96b7:e0e8/64 Scope:Global
inet6 addr: 2001:470:xxxx:xxxx:55af:8fcb:3d10:84aa/64 Scope:Global
inet6 addr: 2001:470:xxxx:xxxx:290:a9ff:fe72:18a8/64 Scope:Global
inet6 addr: fe80::290:a9ff:fe72:18a8/64 Scope:Link
inet6 addr: 2001:470:xxxx:xxxx:fd83:3227:a7f1:3735/64 Scope:Global
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:808381 errors:4 dropped:0 overruns:0 frame:4
TX packets:381375 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:1147631427 (1.0 GiB) TX bytes:33745708 (32.1 MiB)
ccain wrote:Thanks for the reply Mark (I hope I'm assuming correctly that is your name).
All-in-all, I am not concerned that there are 8-9 Global addresses at any given time on my device. It just didn't look right and I wanted to know if anyone else had noticed this.
I have one other question that I hope you can help me with. I've assigned a manual IPv6 Global address to the device, but in order for the address to bind to the NIC autoconfiguration must be enabled. Is this correct? I thought that I'd be able to manually assign an IPv6 address and disable autoconfiguration but that doesn't seem to work. It looks like IPv6 is disabled if autoconfiguration is disabled. Is this a bug?
Users browsing this forum: No registered users and 1 guest