Hello, I have to upgrade the firmware from 0.4.5.3 to 0.4.7.3, after the procedure was restarted and it stops after the WD logo. I tried but I just telnet. ssh if I try to "cd" hangs the connection. I tried to rename the wdtvhd.bin in emergency-wdtv.bin and created a file emergecy-flash, flash part of the procedure but remains at 0%. I do not know what to do ... Help
leighcb wrote:Same here. Upgrading from 4.5.3, now stuck at the WD logo. Any way to recover or is the WD a brick?
I had the same issue when upgradeing from 0.4.1.9-6 to 0.4.5.3. It turned out to be the USB flash drive I was using. It worked fine for everything else but for some reason it was no good for flashing my WDTV-G2. Once I switched to another flash drive I was able to restore 0.4.1.9-6 using the emergency recovery mode and then flash 0.4.5.3 without issue. Try flashing back to 0.4.1.9-6 using the recovery mode and then flash to 0.4.7.3 using a different flash drive that has been formatted FAT32.