first of all, i have to say how much i appreciate the work you are doing here - you rock, and please keep it on
now, to the issue - actually it's the same issue i was facing when with the original firmware. the reason i updated was mainly this, because otherwise i was fine with the official one, but now i'm not going back anymore
so basically i'm sure you're familiar with the problem: i turn the device off with the remote, and it turns off, and there's no turning it back on. the LED comes up, shines nicely, but on the TV it just says no signal, and nothing happens, ever. Only if i remove the power cord and put it back again can i bring it back to life.
I was hoping this new fw would finally do away with that problem - it is SO annoying to get up every time and do the power cycle - and more importantly, you have to explain to certain female beings in the house that THIS is the way to go. And they would naturally do not accept this and complain about what a crappy piece of whatever i got myself.
The version i have is 0.5.1.1 I checked the settings and found stuff about deep sleep, and usb power turnoff and i set every combination now, but to no avail. It turns on, i turn it off with the remote, and bam, no turning back, ever.
i have it hooked up to my router via ethernet. No USB devices, no nothing, just an ethernet and an HDMI to my tv (and audio to the amp). That's it. The TV is an LG LCD tv, not the newest type, but works fairly well.
is there anyone who can help me? Is there a combination of settings that would resolve this?
(sorry if posted in the wrong section but to me this is a bug...)